Why Does My WinCan Video Stutter or Pause During Camera Movement?
If your video repeatedly freezes, stutters or pauses while using WinCan inspection software, there are several checks you can complete to help identify the issue. This may occur when moving or panning the camera during an inspection.
First, determine whether you are experiencing:
If your video repeatedly freezes, stutters or pauses while using WinCan inspection software, there are several checks you can complete to help identify the issue.
This may occur when moving or panning the camera during an inspection.
- Video stuttering: The picture repeatedly stops and starts during camera movement.
- Video delay: The picture remains smooth but appears later than the camera movement.
These are different symptoms and may require different troubleshooting steps.
Step 2: Compare the camera display with WinCan- Open the live camera display on your inspection system.
- Compare the picture with the live video displayed in WinCan.
- Check whether the camera system display runs smoothly while the WinCan video stutters or pauses.
- Note whether the problem occurs during camera movement, such as panning.
This comparison helps SECA technical support investigate where the issue may be occurring.
Step 3: Check whether recordings are affectedDetermine whether the issue appears:
- Only in the live WinCan video.
- Only when playing back a saved recording.
- In both the live video and saved recording.
If the issue affects a saved inspection recording, contact SECA technical support.
Step 4: Check whether the system has been restartedIf appropriate, save your inspection work before restarting the system.
Make a note of whether restarting changes the behaviour.
When to contact SECA technical supportIf the stuttering continues, contact SECA support with the following information:
- Your WinCan software version.
- Your camera system make and model.
- Whether this is a new installation or an existing setup.
- Whether the issue affects live video, saved recordings or both.
- The approximate duration of each pause.
- Whether the camera system display is working normally.
Where possible, provide short comparison videos showing the camera system display and the video in WinCan.
Important: These checks help identify the symptoms but do not confirm the underlying cause. Further investigation may be required before changes to your WinCan configuration can be recommended.